Have your own friends and family hockey games and invite the main neighborhood to join within.

Here’s how to build your superior ice rink:

Figure out where you can build your rink. Try to find the most level section of your yard and then work out how large the rink are going to be. Do not build your rink over a septic system as the massive amount water will cause some tremendous problems!
Level out any sections of your lawn that need to be raised. A level surface is very important for your ice rink. If you have some sections that are lower than they should be, use topsoil or even packed snow to quite possibly them out. (Remember: snow will melt!)
Purchase your backyard ice rink supplies. You need to choose something now: do you want a fancy rink or a basic rink? Here is a listing of basic materials you need (and some fun add-ons too):
2″ x 10″ boards – enough to your border (if you’d like to be really fancy it is possible to look into community rink dasher table systems)
2″ x 2″ stakes – enough to use about every 3′ around your border
Door hinges and deck screws to fasten corners
Plastic sheet – that will act as your ice rink liner. Get enough to hide the bottom of your rink AND flow in the tops of your panels.
Large staples to secure your liner
Duct tape to join the liner in the centre (if you have several piece)
Pond hockey net (x2)
Plywood – this isn’t necessary but can are a puck board. You will need a few 4″ x 4″ s or fence posts to help brace these on the outside would like to go this route. If you’re sincere about, check into a community ice rink dasher table system. *
Marsh Pegs (they can be frozen into your ice surface and maintain net in place)*
Line Kit (to produce those fancy lines on your ice hockey rink)*
Avalanche lights for night games*
*fun add-ons
After your rink area has been leveled out, construct your ice rink frame with the 2″ x 10″ ohydrates, stakes, deck screws, and door hinges. Make sure you do this BEFORE the ground is frozen solid.
Place your ice rink boat inside your frame so that the sides are draping over. Duct tape the liner together in the middle if need be. Leave about a 1′ overlap.
Staple your liner to your frame above the water level or on the outside of the rink.
If putting up a puck board that you can do so now, along with the supports. You may be capable of use your fence discussions for support instead if you are building right to a fence.
Now you are able to flood your rink. This will have to be done in several steps and done when you are fairly certain that the elements will stay cold. The main night, flood your rink with the hose, then for a few consecutive nights, spray the surface until it evens available.
If you are which has a lines kit, do so now before you decide to put the last film or two of winter snow storms on.
portable ice rink, portable ice rink